Boiler Repair Edinburgh Free · no obligationRequest a call-back

What a CP12 costs in Edinburgh

A CP12 — properly a Landlord Gas Safety Record — is priced per property, not per hour, and the price is driven by how many appliances there are and how easy the property is to work in. Here is what goes into the figure, and what to ask before you accept one.

The price bands we publish

JobTypical rangeWhat changes it
Gas safety record, one appliance£60–£100Access, parking, appliance condition
Annual boiler service£70–£100Boiler type, age, condition
Both in one visit£120–£150Booked together, one journey

These are the bands this site publishes, and they are ranges rather than quotes for a reason: nobody can price a specific property without knowing what is in it. Ask for the figure for your address before the visit, and ask what happens if a second appliance is found.

What you are actually paying for

Not the piece of paper. The fee covers an engineer's time on site, the cost of travelling to a city where parking is a real constraint, the liability insurance behind a registered business, and the time to write and issue a record that will stand up if it is ever examined.

A two-appliance property — a boiler and a hob, say — typically takes 30 to 60 minutes. That is why the price is what it is: a competent check is not a five-minute walk-round, and a certificate issued without the flue being inspected is not worth the paper.

What pushes the price up

More appliances

A boiler, a hob, a fire and a water heater is four items, not one. Each takes time and each appears on the record.

Access

A top-floor tenement with no lift, a boiler in a sealed cupboard or an appliance behind furniture all add time.

Parking and permits

Controlled zones in the centre and around the university cost the engineer time or money, and that is in the fee.

Condition

An appliance that has not been looked at in five years takes longer to inspect than one serviced last year.

Defects

An ID or AR finding means the appliance is turned off and the situation explained. Remedial work is a separate quote.

Volume

A portfolio booked together is normally cheaper per property than the same properties booked one at a time.

What a suspiciously cheap certificate hides

The failure mode is not usually a fake certificate. It is a real certificate issued after a check that did not cover what it should have: no flue flow test, no gas rate check, no ventilation assessment, no record of the defects that were plainly there. The record looks complete. It is the work behind it that is missing.

That matters because the record is your evidence. If an incident happens and the investigation finds the appliance was At Risk at the time of the check, a certificate that recorded nothing is worse than no certificate at all — it is a document showing you were told everything was fine when it was not.

Six questions to ask before you accept a quote

  • Is the price per property or per appliance, and what does a second appliance add?
  • Is the flue included, and will it be flow-tested?
  • Is there a call-out or diagnostic charge on top?
  • What do you charge if an appliance is found At Risk and has to be turned off?
  • Will the record be issued on the day, or posted later?
  • Can you hold the anniversary date and remind me when it is next due?

Cost questions

Is a CP12 the same price as a boiler service?
They are usually priced separately and are different jobs. The service covers the boiler; the CP12 covers every appliance, flue and gas pipe in the property. Booking both in one visit is normally cheaper than two visits because the travel and set-up are only paid for once.
Why is my quote higher than a friend's in another city?
Edinburgh gas engineer day rates are among the highest outside London, and city parking and access add to every visit. A quote from outside the city that assumes easy access can end up costing more once the parking and the stairs are real.
Do I pay extra if the engineer finds a fault?
Not for the finding. Any repair is a separate quote that you accept or decline. What you should not pay twice for is the diagnosis — if a repair follows immediately, ask whether the check fee is absorbed.
Can I get a discount for several properties?
Usually, yes. Portfolio work is quoted per property but priced with the travel shared, so ten properties on one day cost less per property than ten separate appointments.

Need an engineer today?

Leave your number and the fault. We pass it to a local heating engineer, who calls you back to arrange the work. Check their Gas Safe registration before any work starts.

Free · no obligationRequest a call-back